Serpent 600753 SRX8 Servo Saver Tuning Nut  [SER600753]

Serpent SER600753 Servo Saver Adjust nut SRX8
Price:
NZD$14.11
Brand:
Serpent
Model:
SER600753
Condition:
Brand New
Write a review
alt="Serpent SER600753 Servo Saver Adjust nut SRX8" title="Serpent SER600753 Servo Saver Adjust nut SRX8"

Steering Precision Upgrade for SRX8 by Serpent 600753

For SRX8 owners who like to dial in handling, the Serpent 600753 Servo Saver Adjustment Nut offers precise control over steering behaviour. It gives the ability to tweak the saver setup so the car tracks more predictably through corners.

Built for Racers and Practice Sessions

The Serpent 600753 uses tough materials and a design focused on repeatable adjustments. That lets you experiment with steering bias and return to a known setting between practice runs or during a race day.

Simple Fitment on SRX8 Chassis

Installation is straightforward on the SRX8 servo saver assembly and does not require elaborate changes. You can make quick setup swaps at the pits and compare results without lengthy downtime.

Will this nut change how much servo throw I need?

It affects saver preload and damping more than throw; you may still keep your existing end points but fine tune the saver to complement servo travel for better steering feel.

Is special tooling required for installation?

Standard small hand tools used for servo saver work are sufficient. Careful, incremental tightening with the correct spanner or pliers is recommended to avoid overloading the threads.

How does it perform on rough surfaces?

The nut helps stabilise steering feedback, but you should still combine it with the right servo and saver settings for loose or abrasive surfaces to prevent excessive wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved