Serpent 600951 Lightweight Carbon Battery Plate for SRX8E  [SER600951]

Serpent SER600951 Battery Mount Plate Carbon set SRX8E
Price:
NZD$90.04
Brand:
Serpent
Model:
SER600951
Condition:
Brand New
1 Reviews
Write a review
alt="Serpent SER600951 Battery Mount Plate Carbon set SRX8E" title="Serpent SER600951 Battery Mount Plate Carbon set SRX8E"
alt="Serpent SER600951 Battery Mount Plate Carbon set SRX8E" title="Serpent SER600951 Battery Mount Plate Carbon set SRX8E"

Race-oriented carbon battery plate for the SRX8E

The Serpent 600951 Carbon Fiber Battery Mount is tailored to the Cobra SRX8E buggy, providing a slim, strong mounting point for saddle pack batteries. Constructed from 2mm carbon fiber, this plate trims weight while increasing chassis torsional rigidity to help you put down cleaner laps. A practical upgrade for club racers and weekend tuners alike.

Benefits at a Glance

  • Material: Premium 2mm carbon fiber for strong but light construction
  • Design: Saddle-style layout secures batteries in the correct position
  • Compatibility: Specifically matched to the Cobra SRX8E chassis dimensions
  • Installation: Fitted with mounting posts and body clips to simplify setup
  • Functionality: Adds stiffness to improve handling precision and consistency

 

Product Reviews
1 Reviews
rating
Great !!! Shipping was so fast !! 4 days from HK to France !! I was a little bit scared before ordering on a site I didn't know before, but communication with RCJaz was good. I'm fully satisfied and will recommand RCJaz for sure. Thank you guy

Can I fit a standard 2S or 3S saddle pack into this mount?

The mount is intended for common saddle pack sizes used in SRX8E setups, but double-check pack dimensions and strap clearance before finalising fitment.

Does the carbon plate change chassis flex characteristics significantly?

Yes, the 2mm plate increases local stiffness, which can sharpen steering response and reduce unwanted flex under load.

Any special tools needed for installation?

No special tools are required; basic hand tools and the supplied posts and clips are normally enough to fit the plate.

How should I maintain the carbon surface after use?

Wipe the plate with a soft cloth and isopropyl or mild soap after dusty runs, and inspect mounting holes for wear periodically.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved