Serpent 600967 Front Antiroll Bar 2.6 mm - Precision Tuning Bar  [SER600967]

Serpent SER600967 Antiroll bar Front 2.6 mm
Price:
NZD$9.68
Brand:
Serpent
Model:
SER600967
Condition:
Brand New
Write a review

Control Upgrades with Serpent 600967 Front Antiroll Bar

The Serpent 600967 Front Antiroll Bar in 2.6 mm diameter helps reduce unwanted roll and improves steering consistency during cornering. It is suited to tuners who make small incremental changes to handling at the track.

Consistent Handling from Thoughtful Design

Built by Serpent, the 2.6 mm specification gives a reliable mix of rigidity and flex so the front end stays predictable across lap after lap. That consistency aids tyre contact and steering feel.

Setup Uses for Club and Track Runs

Whether tweaking for tighter turn-in or more mid-corner stability, the Serpent 600967 can be used to calibrate front roll stiffness. It pairs well with a range of chassis geometries and spring setups.

Which chassis types accept this antiroll bar?

Many modern on-road and 1/10 scale competition chassis can use the Serpent 600967, provided their front linkage points fit the bar geometry. Check your manual or measure mount spacing to confirm fit.

Will a stiffer bar always improve lap times?

Not always. A stiffer front bar can speed turn-in and reduce body roll, but on low-grip or bumpy tracks it can reduce contact and slow lap times. Test changes in small steps.

How should I check fitment during setup?

Fit the bar loosely at first, cycle suspension through full travel, and ensure there is no binding. Once alignment is confirmed, tighten mounts and recheck after a short run.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved