Serpent 600972 2.8mm Rear Antiroll Bar - Circuit Tuner [SER600972]

Serpent SER600972 Antiroll bar Rear 2.8 mm

Price:

NZD$9.68

Brand:

Serpent

Model:

SER600972

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Improve cornering stability with the Serpent 600972 rear bar

The Serpent 600972 Rear Antiroll Bar 2.8mm helps reduce rear body roll so your car stays flatter through turns. Intended for the rear linkage, the 2.8mm wire adds controlled stiffness while retaining enough flex for predictable feedback from the tyres.

Can I swap this between race and practice setups?

Yes, the Serpent 600972 bar is handy for swapping between practice and race trims to quickly alter rear stiffness without changing springs.

Will it change tyre wear or traction?

Expect slightly different tyre load distribution in corners; monitor wear and adjust toe or camber if you notice uneven wear after fitting.

Is the 2.8mm size suitable for all track conditions?

The 2.8mm is a medium-stiff option that works well on typical indoor and outdoor asphalt tracks; for loose or rough surfaces you may prefer a different setup.

Do I need spacers or mounting parts to fit it?

Most Serpent rear mounts accept the bar directly, but some setups need small spacers or shims—check your car's manual to confirm any extra parts.