Serpent 600987 SRX8 Upright Aluminium Inserts - Track Upgrade  [SER600987]

Serpent SER600987 Inserts for upright aluminum V2 (8) SRX8
Price:
NZD$10.85
Brand:
Serpent
Model:
SER600987
Condition:
Brand New
Write a review

Tight-Fit Aluminium Inserts for SRX8

For racers focused on consistent lap times, the Serpent 600987 aluminium inserts are made for SRX8 uprights to give a secure seating point for the wheel assembly. Fabricated from quality aluminium, they reduce flex at the upright interface.

Strength That Keeps Handling Consistent

Aluminium offers better wear resistance than many stock materials, so suspension geometry stays stable across multiple runs without frequent replacement.

Straightforward Installation and Compatibility

These inserts are formed to match the Serpent SRX8 upright profile and fit with common hand tools. They are a practical option whether you are refreshing worn parts or upgrading for tougher use.

What basic tools do I need to fit these inserts?

Typical hex drivers, a soft press or mallet and a cleaning brush are usually sufficient. Take care to press the insert squarely into the upright to avoid damage.

Will these inserts affect alignment settings?

Properly installed inserts should not change overall geometry, but it is good practice to re-check toe and camber after replacing any upright components.

Are these suitable for carpet and low-grip surfaces?

Yes, aluminium inserts are commonly used on carpet tracks because they deliver repeatable steering feel and resist wear from frequent running.

Can I reuse old inserts if they look ok?

If an insert shows no damage, burrs or looseness it can be reused, but replace any unit that has signs of wear to maintain precise fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved