Serpent 601018 Front Suspension Bracket for SRX8 GT - Precision Alloy Part [SER601018]

Serpent SER601018 Suspension Bracket Front Front SRX8 GT

Price:

NZD$61.98

Brand:

Serpent

Model:

SER601018

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Precision alloy front bracket for SRX8 GT by Serpent

The Serpent 601018 Front Suspension Bracket fits the SRX8 GT chassis to deliver reinforced front-end support and consistent alignment under stress. Engineered for a snug fit, it helps preserve suspension geometry during aggressive runs and improves predictability on mixed surfaces. The component works with standard SRX8 GT hardware for a clean retrofit.

Notable features of the Serpent front bracket

Durability: Alloy construction resists deformation from impacts and race wear.
Precision Fit: Designed to match SRX8 GT mounting points for accurate installation.
Enhanced Handling: Increases front-end stiffness to aid turn-in and mid-corner balance.

Specifications

Compatibility: SRX8 GT Chassis
Material: High-Strength Alloy

A solid choice for builders wanting to tighten up SRX8 GT steering and reinforce the front end for tougher track conditions.

Will this bracket work with aftermarket arms?

It is optimised for SRX8 GT mounting. Many aftermarket arms that follow the same geometry will fit, but confirm hole spacing and clearances before fitting.

Does it require special bolts to install?

Installation normally uses stock SRX8 GT fasteners; however using thread locker on steel bolts is recommended for race use.

How does this affect suspension tuning?

With increased front stiffness you may need to soften front shocks or adjust anti-roll settings to retain desired balance.