Serpent 601037 SRX8 GT Chassis Rollbar  [SER601037]

Serpent SER601037 Rollbar SRX8 GT
Price:
NZD$10.98
Brand:
Serpent
Model:
SER601037
Condition:
Brand New
Write a review

Stiffen Your SRX8 GT with the Serpent 601037

The Serpent 601037 Rollbar is tailored for the SRX8 GT to cut down chassis movement and increase resilience during aggressive runs. It suits enthusiasts focused on handling precision and repeatable setup results.

Performance Gains from the Rollbar

This component adds strategic bracing to the chassis, helping to stabilise weight transfer and reduce unexpected flex. The result is a steadier car that responds more predictably lap after lap.

Simple Installation Notes

The rollbar mounts to existing SRX8 GT points, making fitting straightforward with common RC tools. After installation, recheck the mountings after a few sessions to ensure everything remains tight.

Will this affect my car's handling balance?

Yes, it can slightly change chassis stiffness which may alter balance; expect to adjust setup to fine tune handling to your preference.

Can I paint or finish the rollbar?

Surface finishing is possible depending on material; prepare the surface and use compatible paints or coatings for a neat result.

Is special hardware required to fit it?

No special fasteners are normally needed beyond standard RC screws, though check your car's parts before starting to be sure you have the right sizes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved