Serpent 601038 - SRX8 GT High/Low Aluminium Pinion Mount Performance Fit  [SER601038]

Serpent SER601038 Pinion Mount Aluminium H/L SRX8 GT
Price:
NZD$65.79
Brand:
Serpent
Model:
SER601038
Condition:
Brand New
Write a review

Precision Pinion Mount for SRX8 GT by Serpent

The Serpent 601038 High/Low Aluminium Pinion Mount is crafted to bring reliable alignment and tougher construction to the SRX8 GT. Its aluminium build reduces flex and helps keep gear mesh steady across practice and race sessions.

Stability That Lasts

Aluminium construction gives this mount a longer service life than typical composite parts, maintaining correct geometry after heavy runs. That stability helps prevent premature wear on pinion and spur teeth.

Tuneability for Different Tracks

The high and low positions let you adapt the pinion height to different spur gear types and track conditions. Use the setting that best balances noise, wear and drive feel for your layout.

Can I use this with different spur gear sizes?

Yes, the high/low adjustment helps accommodate a range of spur sizes, but you should still verify clearance and mesh before finalising your setup.

Is extra hardware needed for installation?

The mount typically fits using the standard SRX8 GT fasteners. Keep original screws and refer to the chassis manual for torque settings to avoid stripping or overtightening.

How often should I inspect the pinion mount?

Check alignment and hardware after the first few runs and then as part of routine maintenance. Look for loosening or unusual wear on gear teeth that could indicate a setup issue.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved