Serpent 601093 SRX8T Rear Suspension Front Bracket - Race Upgrade  [SER601093]

Serpent SER601093 Suspension bracket Rear Front SRX8T
Price:
NZD$52.38
Brand:
Serpent
Model:
SER601093
Condition:
Brand New
Write a review

Serpent 601093 Suspension Bracket for SRX8T Chassis

Hobbyists aiming for cleaner handling will appreciate the Serpent 601093 suspension bracket. Built with SRX8T compatibility in mind, this rear front bracket adds strength to the mounting area and helps the truggy track truer under load.

Built for Durable Performance

The bracket is manufactured to tight tolerances so it copes with regular racing and practice sessions. Its form is intended to enhance robustness and maintain consistent handling lap after lap, making it suitable for both informal running and event use. Fitting the bracket typically improves predictability through turns.

Compatibility Notes and Installation

This part is designed for the Cobra SRX8 Truggy GP (SER600059) and sits within the Cobra SRX8 Buggy Series family. The unit installs with standard RC workshop tools, allowing quick upgrades without lengthy rebuilds. It is engineered to align with the SRX8T chassis for a secure fit.

Can I use this bracket on an older SRX8 chassis?

Older SRX8 variants may differ in mounting points, so check measurements before assuming compatibility; this item is intended for SRX8T layouts.

Does the bracket need any setup changes?

No mandatory setup changes are required, though you may fine tune camber or toe to suit track conditions after fitting.

How should I maintain the bracket?

Inspect fasteners after initial runs and check for any movement; reapply thread lock if needed and clean mounting faces to prevent wear.

Is this a good upgrade for club racing?

Yes, it provides a stronger mounting point which can help consistency in club race conditions without altering basic geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved