Serpent 601103 Front Antiroll Bar 2.2mm for SRX8T [SER601103]

Serpent SER601103 Antiroll bar Front 2.2mm SRX8T

Price:

NZD$9.53

Brand:

Serpent

Model:

SER601103

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Dial In Roll Stiffness on the SRX8T

Fit the Serpent 601103 front antiroll bar to your SRX8T to adjust front roll resistance on the Cobra SRX8 Truggy GP. The 2.2mm section is intended to help you tune turn-in and midcorner attitude for cleaner lap times.

Why Racers Use This Bar

Precision Engineering: 2.2mm thickness gives a dependable compromise between flexibility and control for varied track layouts.
Durable Construction: Manufactured to hold up under repeated running and rough club conditions.
Model-Specific Fit: Designed to match the geometry of the Serpent SRX8T for hassle-free mounting.

Is the 601103 bar a direct replacement for the stock part?

Yes, the 601103 is designed as a direct front antiroll bar for the SRX8T and installs using the same mounting points as the original front bar.

Will it reduce understeer or oversteer?

Increasing front roll stiffness tends to reduce body roll and can make the car less prone to understeer on entry, but it should be tuned alongside rear settings for balance.

What tools are needed to fit it?

Basic hand tools are sufficient: hex drivers and pliers for endlinks, plus thread lock for metal-to-metal fasteners if required.

How should I test changes after fitting?

Make one change at a time and run multiple laps to assess. Note corner entry, midcorner balance and exit traction to decide next adjustments.