Serpent 601105 2.4mm Front Antiroll Bar for SRX8T - Precision Setup  [SER601105]

Serpent SER601105 Antiroll bar Front 2.4mm SRX8T
Price:
NZD$9.53
Brand:
Serpent
Model:
SER601105
Condition:
Brand New
Write a review

Refine SRX8T Handling with the 601105 2.4mm Antiroll Bar

The Serpent 601105 2.4mm front antiroll bar reduces unwanted chassis lean on the SRX8T, improving steering accuracy and mid-corner stability. Its fitment is aimed at racers who want reliable front-end performance when tuning setups.

Sharper Turn-In for Varied Track Conditions

At 2.4mm thickness this bar increases front roll resistance so the truggy tracks flatter through turns. It is designed to match the Cobra SRX8 Truggy GP geometry for correct handling responses on both loose and firm surfaces.

Consistent Performance and Low Maintenance

Built from quality alloy, the Serpent 601105 is made to tolerate regular racing use while delivering repeatable results. Periodic checks and light maintenance will keep it working as expected.

Will this antiroll bar fit the stock SRX8T without modification?

Yes, the Serpent 601105 is produced to fit the SRX8T stock mounting points for a straightforward swap with minimal changes to your existing setup.

Can I use this bar to tune front bite?

Increasing front roll stiffness with this 2.4mm bar normally increases front grip and bite in corners, but balance it with rear settings so you do not induce oversteer.

How do I look after the antiroll bar?

Keep the mounting area clean, inspect the bar and linkages for wear, and ensure fasteners are secure before each running session to maintain consistent handling.

Is this suitable for both practice and race days?

Yes, its predictable stiffness makes it useful for both practice tuning and race day setups where consistent roll control matters.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved