Serpent 601107 - SRX8T 2.6mm Front Antiroll Bar Track Setup  [SER601107]

Serpent SER601107 Antiroll bar Front 2.6mm SRX8T
Price:
NZD$9.53
Brand:
Serpent
Model:
SER601107
Condition:
Brand New
Write a review

Tune Control with Serpent 601107 - SRX8T

The Serpent 601107 - SRX8T 2.6mm front antiroll bar is designed for use on Cobra SRX8 Truggy GP cars to cut roll and stabilise the front end under load. Its diameter provides a consistent response when steering hard into corners.

Performance Effects of a 2.6mm Bar

A 2.6mm bar increases lateral stiffness at the front, producing sharper cornering and reduced chassis squat. This makes lap times more repeatable and helps drivers hold their line through complex sections.

Mounting Advice and Care

Install the Serpent 601107 ensuring the links are aligned and fasteners are torqued to spec. Regular checks for secure mounts and straightness will extend service life, and the part fits across the Cobra SRX8 Buggy Series for varied setups.

Can I use this bar on a standard SRX8 buggy?

The bar is targeted at Cobra SRX8T and SRX8 buggy variants. Many SRX8 buggies share mounting formats, but check the linkage lengths and hole positions before installing to avoid binding.

Will this reduce understeer on loose surfaces?

A firmer front bar helps control body roll and can reduce understeer in many cases, but you may also need to tune rear bar stiffness and damping to achieve the best balance on loose tracks.

What routine checks should I do after a race?

After running, check for bends, worn link ends and loose hardware. Tighten ball connectors if needed and replace any worn links to keep the antiroll bar performing consistently.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved