Serpent 601136 Rear Carbon Wishbone Insert SRX8T Upgrade  [SER601136]

Serpent SER601136 Wishbone insert carbon Rear SRX8T
Price:
NZD$86.89
Brand:
Serpent
Model:
SER601136
Condition:
Brand New
Write a review

Carbon Reinforced Rear Arm for SRX8T

The Serpent 601136 carbon wishbone insert is manufactured to stiffen the rear suspension of the SRX8T. Built from durable carbon fibre material, it increases the arm's resistance to flex and wear, giving a steadier rear end under load. Ideal whether you are refreshing worn parts or tuning for crisper handling on the circuit.

Why Use Carbon in the Rear Suspension

Carbon fibre offers high stiffness without excessive weight, so the Serpent 601136 insert tightens up chassis response while keeping mass low. The result is sharper turn-in, steadier mid-corner balance and more predictable throttle transitions out of corners.

SRX8T Fit and Quick Install

Specifically designed for the Serpent SRX8T, this insert slots into the stock wishbone arrangement and requires minimal adjustment. Fit it using standard shop tools and re-check alignment after installation to ensure optimal handling.

Will this change my suspension tuning?

Yes, the added stiffness shifts rear response; you may want to adjust spring rates or anti-roll settings to balance handling after fitting the insert.

Is the part compatible with stock wishbones?

The insert is made to work with the SRX8T wishbone configuration. It should integrate with the stock arms, though you should confirm fitment before final assembly.

How should I maintain the carbon insert?

Inspect the insert for surface damage after crashes and keep mounting points clean. Carbon is durable but check fastener tightness periodically to avoid play.

Can this reduce unsprung mass?

While the insert is lightweight, its main role is to increase stiffness rather than significantly lower unsprung mass. It helps handling by limiting arm flex.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved