Serpent 601140 Offset Wheel Hex 1mm for Cobra SRX8 Series  [SER601140]

Tune Cornering with the Serpent 601140 1mm Offset Hex

The Serpent 601140 provides a targeted 1mm offset to refine the behaviour of Cobra SRX8 Buggy and Truggy platforms. This small adjustment helps stabilise the chassis in turns and gives more predictable steering feel for drivers dialing in their setup.

Benefits of a 1mm Stance Change

Adding 1mm of offset widens the effective track and can reduce roll and snap oversteer in tight corners. It is a modest change that often yields better mid-corner stability without upsetting existing suspension geometry.

Compatibility Notes and Mounting

Built for the Serpent Cobra SRX8 Buggy and Truggy GP family, the wheel hex is intended for direct swap with factory components. Installation typically takes a few minutes and maintains a low rotating mass to preserve handling balance.