Suspension Tune Hingepins Serpent 601203 - SRX8 RTR Front/Rear Hingepin Set [SER601203]

Serpent SER601203 Hingepin Front/Rear (4) SRX8 RTR

Price:

NZD$31.13

Brand:

Serpent

Model:

SER601203

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Accurate Hingepins for Vintage Handling

Refit your Serpent SRX8 RTR with the 601203 Hingepin Set to improve front and rear suspension reliability. Designed with vintage 1/10 racers in mind, these pins help maintain correct geometry while resisting wear from repeated running.

Why These Hingepins Matter

Durable Construction: Built from robust materials to take knocks and repeated use.
Enhanced Compatibility: Engineered for a straightforward fit on the SRX8 RTR chassis.
Precision Engineering: Helps keep suspension alignment true lap after lap.
Versatile Use: Can be used front and rear, simplifying spares and servicing.

Can I swap these into other Serpent vintage cars?

They are specified for the SRX8 RTR but may fit other vintage Serpent models if the mounting hole and pin sizes match. Measure before swapping.

Should I replace both front and rear pins at once?

Replacing the full set helps maintain even wear and consistent suspension feel, so many hobbyists change them as a set during maintenance.

Do these require break in?

No special break in is needed. After installation, check clearances and re-tighten fasteners after a few short runs.

Can I tune handling with different pin materials?

Material and stiffness can influence feel. Swapping to harder or softer pin designs is a common tuning step, but start with the OEM 601203 set for baseline setup.