Serpent 601204 44T Spur Gear SRX8 Tuning Part  [SER601204]

Serpent SER601204 HTD Spur Gear 44T SRX8 RTR
Price:
NZD$54.71
Brand:
Serpent
Model:
SER601204
Condition:
Brand New
Write a review

How the 44T Upgrades SRX8 Drive Feel

The Serpent 601204 HTD Spur Gear is purpose-built for the Cobra SRX8 Buggy and Truggy range, featuring a 44-tooth arrangement that improves drivetrain harmony. It helps deliver more predictable throttle response and lowers parasitic drag for better efficiency across lap sessions.

Why the 44-Tooth Choice Works

A 44T spur gives a useful middle ground between top speed and pulling power, while the HTD profile reduces friction where it matters. This yields more consistent acceleration and less heat buildup in transmission components during extended running.

Compatibility and Quick Swap Tips

The gear fits the Cobra SRX8 Buggy Series and Cobra SRX8 Truggy EP RTR (SER600039). Swap it in with standard tools, set an accurate pinion mesh, and verify slipper clutch settings after your first test run for best results.

Is backlash or mesh adjustment needed after fitting the Serpent 601204?

After fitting, set the pinion mesh to a snug but free fit to avoid premature wear. Check and fine tune after a short break-in run.

Does the 44T affect motor temperature?

A balanced spur like the 44T can lower drivetrain losses which may reduce motor load slightly, but motor temps still depend on gearing, motor type, and running conditions.

Are there upgrades that pair well with this spur?

Consider a hardened pinion and a tuned slipper setup to match the 44T, especially for high power brushless builds to protect gear teeth and driveline components.

Will this gear improve lap consistency?

Yes, by smoothing power transfer and reducing drivetrain friction you can see more consistent throttle responses which helps maintain repeatable lap times.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved