Serpent 601219 Rear Shock Tower - SRX8 GT RTR Performance Part  [SER601219]

Serpent SER601219 Shocktower Rear SRX8 GT RTR
Price:
NZD$38.23
Brand:
Serpent
Model:
SER601219
Condition:
Brand New
Write a review

Enhance SRX8 GT RTR Suspension with Serpent 601219

The Serpent 601219 Rear Shock Tower improves the rear suspension layout on SRX8 GT RTR models, helping the car hold alignment under cornering loads. It is a practical upgrade for club and competition use.

Precision Engineered Strength

Manufactured to maintain suspension geometry, this rear tower reduces unwanted flex and helps shocks keep a more consistent stroke. The result is clearer feedback and more predictable tyre contact patches.

Model Fit and Installation Notes

Compatible with the SRX8 GTE RTR EP (SER600061), the tower installs using the factory mounting points. Check shock top mount positions after fitting to fine tune ride height and camber settings.

Can I use this on a converted SRX8 chassis?

If the conversion keeps the same rear mounting pattern and shock towers, the Serpent 601219 can be used. Verify hole spacing and clearances first.

Is it compatible with aftermarket shocks?

Most standard top-mount shocks that match SRX8 geometry will fit, but double check shaft length and cap height to avoid binding at full compression.

How should I set up shocks after installing?

Start with your prior spring and damping setup, then test low-speed handling and adjust preload or damping to restore balance. Small increments work best when tuning.

Does the Serpent 601219 require periodic inspection?

Yes, inspect mounting screws and shock top mounts after hard sessions. Tighten hardware and check for cracks to maintain safe operation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved