Serpent 601232 Steeringblock Ballstud Kit - Race Tuning  [SER601232]

Serpent SER601232 Steeringblock ballstud
Price:
NZD$28.91
Brand:
Serpent
Model:
SER601232
Condition:
Brand New
Write a review

Dial In Steering with Serpent 601232

Tuners wanting crisper steering on the Cobra SRX8 GT will find the Serpent 601232 Steeringblock Ballstud Kit useful. These studs are engineered for accurate movement and endurance, helping reduce unwanted steering play on technical tracks.

Designed for Cobra SRX8 GT Compatibility

The Serpent 601232 set is made specifically for the Cobra SRX8 GT series, so installation is direct and predictable. They help maintain correct steering geometry and improve front-end feedback during hard cornering.

Built to Stand Up to Racing

Using robust materials, these ballstuds resist wear from repeated race use. Their consistent build quality supports steady steering feel lap after lap, making them a sensible upgrade for serious hobbyists.

Are Serpent 601232 studs compatible with older SRX8 parts?

They are intended for the Cobra SRX8 GT but may fit some earlier SRX8 variants if the steeringblock mount points match. Check thread sizes and dimensions first.

Which servo should I pair these with?

These ballstuds work with standard high-torque steering servos used in GT setups. Choose a servo with good centring and minimal backlash to benefit from the improved linkage.

Can I use them on polished or rough surfaces?

They perform well on a range of track surfaces, but keep them clean after gritty or outdoor events to avoid accelerated wear.

How often should I check for wear?

Inspect ballstuds after heavy race days and during routine setup checks. Replace them as soon as you detect side play or rounded contact points.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved