Serpent 801212 Left Steering Block - Retro 835 Chassis Part [SER801212]

Price:

NZD$10.40

Brand:

Serpent

Model:

SER801212

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Write a review

Description
FAQ

Replacement Steering Block for Serpent 835

The Serpent 801212 left steering block is a key replacement part for owners of the Serpent 835 4WD 1/10 235mm model. Engineered to maintain steering geometry, it helps recover original handling characteristics on older cars without compromising fit.

Maintain Authentic Handling

Specifically matched to the 835 4WD chassis, this left steering block gives consistent alignment and predictable steering feel during club events or casual runs. Its compatibility ensures a clean swap when restoring vintage Serpent kits.

Do I need special tools to fit this steering block?

Basic RC tools like hex drivers and pliers are normally sufficient. If your car has been modified, you may need additional spacers or hardware to match older setups.

Can I use this with aftermarket steering links?

Yes, it will accept standard steering links used on the 835 layout, but always double check linkage geometry after installation to avoid bump steer or binding.

What checks should I do after replacing it?

After fitting, verify wheel toe and kingpin alignment, check for free movement through the full steering range, and re-tighten fasteners after a short test run.