Serpent 802526 Centax-3 One Piece Steel Pinion Set  [SER802526]

Serpent SER802526 Centax-3 Gear 16/23T
Price:
NZD$40.20
Brand:
Serpent
Model:
SER802526
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

One Piece Steel Upgrade for Centax-3

The Serpent 802526 Centax-3 Gear Set converts dual pinions into a single hardened steel unit built for the Serpent 720-09 200mm GP vintage cars. The unified design reduces relative movement and improves the contact between pinion and clutch bell compared with split aluminium gears.

Designed to Resist Track Debris

Manufactured from durable steel to stand up to sand and fine grit commonly found on outdoor layouts, this pinion lengthens service intervals. Its 16/23T gearing provides a useful compromise between pullaway and top end on classic GP tracks.

Fast Mounting and Stable Alignment

Fitting is simple: screw the single pinion onto the clutch bell and verify alignment. The integrated part cuts down on setup time and helps keep the drivetrain running true through multiple sessions.

It is optimised for the clutch bell used on the Serpent 720-09 200mm GP kits. Other clutch bells may fit if spline count and diameter match, but measure to be sure before installation.
The added mass is small and concentrated at the clutch, so handling change is minimal. The trade off is longer gear life and steadier clutch engagement.
Inspect tooth faces for pitting and ensure the pinion remains concentric on the clutch bell. Remove debris after runs and replace if teeth show uneven wear.
No special tools are needed beyond basic screwdrivers and a torque or feel check to secure the pinion to the clutch bell. A dial indicator helps for precise runout checks.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved