Serpent 803175 Radioplate Brace Aluminium for 720-09 Vintage Series  [SER803175]

Serpent SER803175 Bracket Radioplate Support Aluminium
Price:
NZD$71.36
Brand:
Serpent
Model:
SER803175
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Serpent 803175 support bracket for vintage GP chassis

Engineered for owners of classic GP cars, the Serpent 803175 Aluminium Radioplate Support Bracket stiffens the radioplate area on the 720-09 200mm GP chassis to reduce flex and sharpen turn-in response.

Why aluminium helps handling

Using aluminium increases structural control without dramatically raising mass, so the car keeps a nimble feel while gaining improved chassis consistency across a run.

Installation and compatibility notes

The bracket aligns with the 720-09 200mm GP chassis mounting points for a straightforward fit; minimal adjustments are normally required for a correct install.

Specifications

  • Material: Aluminium
  • Compatibility: 720-09 200mm GP Chassis

For club racers and collectors who run vintage layouts, the Serpent 803175 is a neat upgrade that brings steadier handling without major setup changes.

Can I use this on a modified 720-09 chassis?

If your chassis retains the original radioplate mounting pattern it should fit; if modifications altered hole locations you may need minor drilling or spacers.

Will it affect corner speed?

By reducing unwanted flex the bracket can help maintain suspension geometry under load, which often improves corner speed and consistency lap after lap.

Do I need special tools to fit it?

Typical hand tools like hex drivers and a small torque driver are sufficient; no specialist machining is required for standard installs.

Is the finish corrosion resistant?

The aluminium part is naturally corrosion resistant but wiping off salt and grime after wet runs will prolong its appearance and service life.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved