Serpent 803181 Carbon GTP Mount Support Plate - Lightweight Upgrade  [SER803181]

Serpent SER803181 Support Plate GTP Mount Carbon
Price:
NZD$30.19
Brand:
Serpent
Model:
SER803181
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Fine-Tune Chassis Balance with Serpent Carbon Plate

The Serpent 803181 carbon support plate is a precision upgrade for modelers aiming to sharpen GTP mount stability. Constructed from quality carbon fibre, it stiffens the mounting area without a heavy penalty, helping the car stay composed on both short tracks and longer layouts.

Stiffness Where It Matters

By reinforcing the GTP region, this plate reduces unwanted movement and helps the suspension work more predictably. The low mass of carbon fibre preserves overall weight distribution for improved traction and response.

Simple Fitment to Common Mounts

Compatibility is broad for typical GTP designs and the Serpent 803181 installs with standard fasteners. Minimal setup changes are usually needed, so you can get back on the circuit quickly.

Will this work on older GTP mount patterns?

It fits many common GTP layouts, but check hole spacing against your chassis. Minor drilling may be required for legacy setups.

Does the plate affect ride height?

The plate itself is thin and should not significantly change ride height, though final stack-up with other components can alter clearance slightly.

Any special tools needed for fitting?

Basic hand tools and a torque-aware driver are usually sufficient. If holes need adjustment, a fine drill and steady hand will do the job.

How do I check for damage after a crash?

Inspect the plate for delamination, deep gouges or cracks and confirm mounting points remain flat. Replace if any structural compromise is visible.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved