Serpent 803182 Carbon Suspension Support for GTP Chassis - Precision Fit  [SER803182]

Serpent SER803182 Suspension Support GTP Carbon
Price:
NZD$30.19
Brand:
Serpent
Model:
SER803182
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Fit a Serpent 803182 support to stiffen your GTP chassis

Club racers and hobbyists will appreciate the Serpent 803182 Carbon Suspension Support as a focused upgrade. Made for GTP chassis, it brings added rigidity without significant weight gain so your setup stays responsive on short, technical layouts.

Why carbon helps handling

Carbon fiber offers a high strength-to-weight ratio that reduces unwanted flex in suspension mounting areas. This leads to more consistent geometry under load and steadier steering input at speed.

Designed for GTP mounting points

The Serpent 803182 matches GTP chassis attachment locations for a neat, direct installation. It works well when replacing age-worn supports or when refining a race setup for sharper turn-in.

Fitting pointers

  • Wipe mounting zones free of grease before installing the support.
  • Use the correct size fasteners and avoid over-tightening to prevent cracks.
  • Re-check suspension travel and camber after installation to confirm geometry.

Can I use Serpent 803182 on foam tracks and carpet?

Yes, the carbon support performs well on carpet and foam where preserving geometry improves lap consistency, though setup tuning may still be needed.

Does the support change ride height?

The part itself does not alter ride height, but the added stiffness can affect how the car settles; adjust springs or droop as needed after fitting.

What hardware should I use with carbon?

Use high-quality countersunk screws or aluminium spacers compatible with GTP pattern and avoid overtightening to protect the carbon layup.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved