Serpent 804103 Kevlar Belt Pack for 733 Chassis  [SER804103]

Serpent SER804103 Belt Set 733 (3)
Price:
NZD$45.20
Brand:
Serpent
Model:
SER804103
Condition:
Brand New
Write a review

Kevlar Belt Upgrade for the Serpent 733

If you run a Serpent 733 and want tougher drive components, the Serpent 804103 Kevlar Reinforced Belt Set is a direct upgrade. The kit includes three belts: a rear belt 5mm wide with 186 teeth, a front belt 4mm wide with 195 teeth, and a side belt with 378 teeth to cover the full drivetrain.

Stronger Material for Stable Power Transfer

Keepsake-grade Kevlar fibres reinforce these belts to reduce stretch and abrasion under race conditions. The correct tooth counts help maintain smooth power flow, lowering the risk of belt jump or uneven drive under hard acceleration.

Simple Fitment for Fast Turnaround

Designed to match the Serpent 733 without modification, this Serpent 804103 set is straightforward to fit so you can swap belts between sessions and get back to tuning or racing quickly.

Are these suitable for off-road use?

The Kevlar reinforcement helps durability on rough surfaces, but check for debris buildup and keep tensioned correctly after off-road runs.

Do I need special tools to install them?

No special tools are required beyond basic RC setup tools; follow pulley alignment and tension procedures to avoid premature wear.

How do I match belt tension front to rear?

Use consistent tensioning method and check tooth engagement on pulleys; small adjustments at the tensioner will balance front and rear drive.

Are these belts compatible with aluminium pulleys?

Yes, they work with aluminium or plastic pulleys but confirm pulley tooth profile and alignment to prevent uneven wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved