Serpent 804177 Front Anti-Rollbar Kit - 1.8mm to 2.8mm Set  [SER804177]

Tune Handling with the Serpent 804177 Four-Bar Set

Hobby drivers looking to refine corner entry and mid-corner balance will find the Serpent 804177 Front Anti-Rollbar Set very handy. Included are four bars at 1.8mm, 2.2mm, 2.5mm and 2.8mm so you can experiment with roll stiffness and find the right setup for each circuit.

Control Roll Without Compromise

Swapping between thicknesses gives visible differences in chassis roll and front grip. Thinner bars allow more independent wheel movement while thicker bars tighten turn-in and reduce leaning through corners.

Compatibility Notes and Swap Tips

These anti-rollbars are made for Serpent chassis and are quick to change during a pit session. Check link lengths and mounting points before swapping to ensure correct geometry and avoid binding.