Serpent 804211 Aluminium Chassis Side Stiffener - Track Ready  [SER804211]

Serpent SER804211 Chassis Side Stiffner Aluminium
Price:
NZD$29.44
Brand:
Serpent
Model:
SER804211
Condition:
Brand New
Write a review

Machined Aluminium Brace for Serpent 733

The Serpent 804211 Aluminium Chassis Side Stiffener is made specifically for the Serpent 733 to replace the stock nylon plate. CNC machined from aluminium with a grey anodised finish, it helps maintain correct spacing for Centax and 2-speed gearing during demanding use.

Durability and Clean Installation

This aluminium stiffener increases sidewall rigidity while keeping weight low and presenting a tidy, countersunk mounting surface. The accurate machining ensures the stiffener sits true, delivering consistent performance for club racers and weekend tuners alike.

Is the Serpent 804211 anodised?

Yes, this part comes with a grey anodised finish that improves corrosion resistance and gives a professional look compared with raw aluminium.

Will this change gear mesh or require shim adjustments?

Because the 804211 is designed as a direct replacement, gear mesh normally stays the same. Check your mesh after installation and adjust shims if needed to suit your setup.

What maintenance does the aluminium stiffener need?

Periodic inspection for burrs or stripped countersinks is recommended. Clean and lightly lubricate nearby moving parts but avoid putting lubricant on the anodised surfaces.

Can I use this on a car that sees off road use?

The aluminium stiffener is tougher than the nylon original and suits mixed surface use, though heavy crashes can still damage any chassis component.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved