Serpent 804289 Rear Anti-roll Bar 2.1mm - Precision 1/10 Scale Tuning [SER804289]

Serpent SER804289 Anti-roll bar Rear 2.1mm

Price:

NZD$9.53

Brand:

Serpent

Model:

SER804289

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Steady Cornering with Serpent 804289 for 1/10 RC Cars

If you want steadier corner entries and cleaner exits, the Serpent 804289 rear anti-roll bar at 2.1mm brings extra control to 1/10 scale models. It cuts down on roll and lets you keep power on earlier without surprise weight transfer.

Main Advantages

Precision Engineering: Built to tight tolerances so flex characteristics remain consistent lap after lap.
Improved Handling: The 2.1mm section increases chassis roll stiffness, which helps tyres maintain contact under cornering loads.
Easy Installation: Designed to mount on a wide range of 1/10 scale platforms for straightforward fitting.

Can I fit the Serpent 804289 to a racing buggy?

It is primarily aimed at 1/10 on-road layouts; some buggy frames may accept it but verify bracket geometry first.

Will it make the car feel harsher over bumps?

Increasing roll stiffness can transfer more impact to the suspension, so pair the bar with appropriate spring and damper settings for your surface.

What should I check before buying?

Confirm the sway bar mount spacing and link type on your chassis to ensure a clean fit and correct geometry.

Is this suitable for both practice and race days?

Yes, it is suitable for both; use it to dial in balance during practice and then fine tune for qualifying or race conditions.