Serpent 804344 2.2mm Rear Antiroll Bar for 748 Chassis - Precision Handling  [SER804344]

Serpent SER804344 Antiroll bar 2.2 Rear 748
Price:
NZD$9.99
Brand:
Serpent
Model:
SER804344
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Get Sharper Turns with a 2.2mm Rear Antiroll Bar

For hobbyists looking to refine a Serpent 748, this 2.2mm rear antiroll bar is a practical upgrade that trims unwanted roll. It suits drivers who want steadier behaviour through corners and clearer feedback from the rear end.

Balance Between Stiffness and Flex

Specifically matched to the Serpent 748 chassis, the 2.2mm bar offers enough stiffness to control roll while still allowing the rear to find grip. That compromise helps keep lap times consistent across changing track conditions.

Quick Installation Advice

Fit the bar with care, checking link lengths and mounting hardware for symmetry. Small mismatches can cause uneven response, so confirm alignment and retest after a few runs.

Can I use this with different suspension setups?

Yes, but the bar changes how the rear reacts to springs and dampers. You may need to soften or stiffen other settings to rebalance handling after fitting the 2.2mm bar.

What on-track effect should I expect?

Expect reduced body roll and crisper turn-in. Depending on the rest of the setup, you may notice slightly earlier rotation or a change in rear traction characteristics.

How often should I inspect the part?

Check mounting points and linkage wear periodically, especially after impacts. Routine inspections keep the antiroll bar working as intended and prevent loose or noisy behaviour.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved