Serpent 804401 Aluminium CVD Wheel Axle Upgrade for Natrix 748/733  [SER804401]

Serpent SER804401 Wheel-axle set CVD Aluminium (2)
Price:
NZD$97.83
Brand:
Serpent
Model:
SER804401
Condition:
Brand New
Write a review

Lightweight CVD Axles from Serpent 804401

The Serpent 804401 Aluminium CVD Wheel Axle Set is purpose made for the Natrix 748 and 733 range. Constructed from hard-coated aluminium, these axles reduce rotating mass compared with spring steel, helping the car respond quicker to driver inputs.

Front and Rear Compatibility

The design allows installation both front and rear to provide consistent handling changes across the chassis. At roughly 60% lighter than steel parts, the aluminium axles contribute to sharper acceleration and more controllable braking behaviour.

Use Aluminium with Steel Where It Counts

For endurance or long mains, pairing aluminium wheel axles with steel driveshafts keeps strength in heavy use areas while still lowering weight at the wheels. This mix helps retain reliability without losing the lightweight advantage.

Specifications

  • Material: Hard-coated Aluminum
  • Compatibility: Serpent Natrix 748/733
  • Weight Reduction: Approx. 60% lighter than steel

Can I run these on both axles at once?

Yes, they are suitable for front and rear installation. Running them all around gives the most consistent reduction in rotating mass and the most noticeable handling change.

Are aluminium axles prone to damage?

Aluminium is lighter but can show different wear patterns than steel. Inspect for nicks and check joints after hard impacts. Using steel for high wear driveshafts is a common precaution.

Do I need new bearings or hardware?

Most installations re-use existing bearings and hardware, but verify clearances and tightness. Replace any worn fasteners or bearings to ensure reliable fitment.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved