Serpent SER804411 Rear Bearingblock Pair for Natrix 750  [SER804411]

Serpent SER804411 Bearingblock up Rear Left + Right S750
Price:
NZD$109.30
Brand:
Serpent
Model:
SER804411
Condition:
Brand New
Write a review

Rear Bearingblock Serpent SER804411 for Natrix 750

The Serpent SER804411 bearingblock supports the rear left and right assemblies on the Natrix 750, helping the rear act predictably under load. It is designed to integrate with the Natrix rear geometry for consistent tracking.

Compatibility and fitting notes

Specifically shaped for the Natrix 750 chassis, this bearingblock is a direct replacement or upgrade option. Fitting is typically done with common RC workshop tools and a simple alignment check afterwards.

Why the SER804411 matters

Accurate rear mounts help keep suspension movement true to setup, and the SER804411 reduces unwanted movement at the rear. Regular inspection after rough runs will help you spot wear early.

Is the SER804411 a direct swap for the Natrix 750?

Yes, it is made for the Natrix 750 mounting pattern and will replace the rear left and right bearingblocks without major modification.

Do I need special grease or bearings when installing?

Standard bearing grease or light oil for adjacent bearings is fine. Make sure bearings rotate freely and that no excess lubricant contaminates suspension joints.

Can I tune handling with different bearingblocks?

Minor handling changes can come from different mount tolerances. If you change bearingblocks, recheck toe and camber as part of setup tuning.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved