Serpent SER804436 Precision Belt Tensioner for Natrix 750  [SER804436]

Serpent SER804436 Belt Tensioner set 1/10
Price:
NZD$52.29
Brand:
Serpent
Model:
SER804436
Condition:
Brand New
Write a review

Natrix 750 Drive Stability Upgrade with Serpent SER804436

The Serpent SER804436 Belt Tensioner supports the Natrix 750 200mm GP car by keeping belts correctly tensioned to improve drivetrain consistency. Proper tension helps limit belt stretch and preserves pulleys and belts over time.

Compatibility and Function

Specifically shaped for the Natrix 750 layout, the Serpent SER804436 reduces the chance of belt slip during hard acceleration and tight corners. Reliable belt tension contributes to more consistent lap times and predictable handling.

Basic Fitting Steps

Installation is straightforward for anyone familiar with 1/10 GP maintenance. Position the tensioner, secure the mounting points, and run a short test to fine tune tension. Small adjustments after initial fitting will lock in the correct setup.

Is the Serpent SER804436 hard to fit on a stock Natrix 750?

No, the unit is designed to match the stock mounting points. Basic familiarity with chassis assembly is enough to complete the job in a short session.

Which type of drive belts should I use with this tensioner?

Use the standard drive belts recommended for the Natrix 750. The tensioner stabilises commonly used belts but will not change the belt specification required by the car.

How do I maintain the tensioner for long term use?

Inspect the unit during routine maintenance, clean any grit from the belt area, and recheck belt tension after extended runs or heavy use to prevent premature wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved