Serpent SER804439 1/10 Centax Nickel Coated Aluminium Clutchbell V2 [SER804439]

Serpent SER804439 Centax Clutchbell 1/10 Aluminium Nickel Coated V2

Price:

NZD$49.17

Brand:

Serpent

Model:

SER804439

Condition:

Brand New

Quantity:

Write a review

alt="Serpent SER804439 Centax Clutchbell 1/10 Aluminium Nickel Coated V2" title="Serpent SER804439 Centax Clutchbell 1/10 Aluminium Nickel Coated V2"

Description
FAQ

Centax Clutchbell by Serpent SER804439 for Track Use

The Serpent SER804439 Centax Clutchbell is an upgrade targetted at 1/10 scale racers who want a tougher clutch bell without added mass. Aluminium construction keeps inertia low while the nickel coat helps resist surface damage from repeated engagement.

What Makes This Clutchbell Useful

Material: Lightweight aluminium construction reduces spin inertia for crisper throttle response.
Coating: Nickel plating provides a harder contact surface to limit wear.
Compatibility: Works with numerous 1/10 transmissions to improve clutch consistency.

Installation Notes and Upkeep

Installation is simple for experienced hobbyists and beginners alike, needing only common tools. Make sure the clutch shoes and spindle are clean before assembly, and check engagement after a few runs to ensure proper set up.

Is the bore size standard on this clutchbell?

Bore sizes can vary by application, so verify the bell bore and any required shims match your gearbox specs before fitting.

Can I polish the nickel surface if it gets marked?

Light scuffs can be cleaned with a fine polish, but avoid aggressive abrasion that could remove the plating; inspect after polishing for any changes in fit.

Should I change clutch springs after upgrading?

If you notice altered engagement or slippage, adjust or replace springs to match the new bell characteristics and restore intended clutch behaviour.