Serpent 808226 19T Pulley and Washer Vintage Series Service Kit [SER808226]

Price:

NZD$5.38

Brand:

Serpent

Model:

SER808226

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Write a review

Description
FAQ

Drivetrain Pulley and Washer for Vintage 1/10 Models

The Serpent 808226 19T pulley and washer set is built for use with the Serpent 835 4WD 1/10 vintage series to keep drivetrain geometry and belt tracking correct. The part helps maintain consistent torque transfer under racing loads and is a smart spare for anyone preserving period-correct performance. Use it during routine servicing or when refreshing a restored car.

Can I use this pulley on a modified shaft?

If the shaft size and keying match the Serpent 835 spec, the pulley will fit. For modified shafts check bore dimensions and secure seating to avoid slip under load.

Is the 19T tooth count suitable for track use?

Yes, the 19 tooth design provides a compromise between acceleration and top speed that suits the Serpent 835 setup on most club tracks.

Should I replace washers when swapping pulleys?

It is recommended to fit fresh washers if the originals show wear. Clean contact faces and fit the washer as shipped to maintain correct spacing and prevent side load on bearings.