Serpent 903124 Viper 989 GP Rear Suspension Arm  [SER903124]

Serpent SER903124 Wishbone Rear UP
Price:
NZD$1,351.74
Brand:
Serpent
Model:
SER903124
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fit Serpent 903124 to Your Viper 989 GP

The Serpent 903124 Rear Wishbone is a direct-fit replacement for the Viper 989 GP chassis. It preserves suspension alignment under load and helps deliver predictable responses when pushing hard on the track. Durable by design, it suits racers who want consistent handling lap after lap.

Track Benefits and Stability

By supporting the rear suspension geometry, this wishbone helps distribute forces across the chassis more evenly, improving balance and reducing snap over bumps. It can be a simple upgrade to refine cornering stability and throttle control.

Compatibility and Quick Swap

Constructed to match the Viper 989 GP mounting points, the wishbone installs cleanly into the existing setup. The easy swap means minimal bench time and fast return to running sessions.

Can I use this with aftermarket uprights?

Compatibility with aftermarket uprights varies. Check the upright mounting hole spacing against the Serpent 903124 arm to ensure the geometry matches.

Should I replace both sides at once?

For even handling, replace both left and right wishbones together if one side is worn. Matching parts helps maintain symmetric suspension behaviour.

What setup changes are needed after fitting?

Major setup changes are usually unnecessary. Check toe and camber, then run a few test laps and adjust minor trim settings as required for your track conditions.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved