Serpent 903133 Carbon Right Sideplate - Precision Handling Part  [SER903133]

Serpent SER903133 Sideplate R Carbon
Price:
NZD$24.29
Brand:
Serpent
Model:
SER903133
Condition:
Brand New
Write a review

Upgrade Your Rig with Serpent 903133 Carbon Right Sideplate

The Serpent 903133 Carbon Right Sideplate is engineered to add structural strength while keeping mass minimal. Its carbon layup delivers a predictable response that helps drivers exploit traction and fine-tune balance.

Benefits of Carbon in RC Builds

Carbon fiber offers superior stiffness per weight, which translates to crisper steering and consistent feedback lap after lap. The Serpent 903133 leverages that trait for improved cornering control without excess weight.

Compatibility Notes and Mounting Advice

This component pairs well with a variety of chassis designs that accept carbon replacements. Use the correct screw lengths, tighten progressively, and test alignment on a short run to confirm fitment.

Which chassis work best with this part?

It fits many 1/10 touring and 1/8 size layouts that accept Serpent pattern plates. Measure mount points against your chassis before purchasing to ensure compatibility.

Can I drill or trim this plate for custom setups?

Minor trimming is possible with care and the right tools. Work slowly, deburr edges, and avoid cracking the weave near mounting holes.

Is the plate compatible with foam bumpers?

Yes, it will fit behind common bumper setups, but confirm that the bumper does not impose extra stress on the mounting points.

What should I check after the first few runs?

Recheck all fasteners for loosening, inspect for edge wear, and verify there are no new contact points with nearby parts that could affect handling.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved