Serpent 903156 Rear Driveshafts 62mm Pair - Off-Road Ready  [SER903156]

Serpent SER903156 Driveshaft Rear 62mm (2)
Price:
NZD$47.86
Brand:
Serpent
Model:
SER903156
Condition:
Brand New
Write a review

Built for Tough Tracks and Trails

The Serpent 903156 Rear Driveshafts are tailored for hobbyists who tackle mixed surfaces and need a dependable rear drivetrain. The 62mm length suits a range of chassis while delivering steady torque transfer for bashing and club racing alike.

Robust Construction for Daily Use

Designed to handle impacts and repeated load cycles, these driveshafts keep rotation smooth under stress. Their build helps reduce twist under acceleration so you get more predictable throttle response.

Practical Upgrade for Versatility

Whether you swap out worn parts or upgrade a stock setup, the 903156 pair offers a straightforward improvement to drivetrain longevity. They are a sensible choice for owners who want low-maintenance performance.

Will these fit my Serpent buggy or truggy?

They suit several Serpent rear setups, but check wheelbase and hub measurements. If your model needs 62mm rear shafts these are the right length.

Are they OK for wet or muddy runs?

They are durable, but after wet runs rinse and dry the drivetrain and apply fresh light lubricant to prevent corrosion and grit buildup.

Can I upgrade other drivetrain parts alongside these shafts?

Yes, consider matching cups, pins, and dogbones to the same quality level to avoid weak links. Balancing the whole rear assembly gives the best result.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved