Serpent 903224 1/8 Scale Coated Aluminium Pinion Pack  [SER903224]

Serpent SER903224 Gear Pinion set 1/8 (6)
Price:
NZD$72.54
Brand:
Serpent
Model:
SER903224
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Tune Ratios on Your Centax II

Serpent 903224 provides a complete set of six coated aluminium pinions tailored to the Centax II drive. With sizes spanning 15T to 20T, the pack lets you experiment with subtle ratio changes without adding extra weight.

Pinion Selection for Track Versatility

Pinion choices include 15T, 16T, 17T, 18T, 19T and 20T so you can adapt gearing for tight technical sections or faster straights. The incremental steps help you find the sweet spot for grip and speed.

Protected Finish for Consistent Engagement

Each gear is machined from aluminium and given a protective coating to limit wear and maintain tooth profile. The finish keeps gear engagement smooth across repeated runs.

Can I use these with a different motor spline?

These pinions are cut to the Centax II spline standard. If your motor has the same spline dimensions they should fit, otherwise you may need an adaptor or a different pinion.

Do coated pinions need special lubrication?

Use a light gear-safe lubricant on the mesh area if desired. The coating is protective but a thin film of grease helps reduce noise and friction during long runs.

Are these suitable for competition use?

Many racers use coated aluminium pinions for fine tuning. Monitor wear and replace pinions that show tooth damage to keep drivetrain reliability at race level.

What tooth count change affects handling most?

Lower tooth counts increase acceleration while higher counts raise top speed. One tooth change gives a noticeable but manageable shift in behaviour for testing setup options.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved