Serpent 903313 Carbon Rear Shock Tower for 966 Chassis - Lightweight Tuning Part  [SER903313]

Serpent SER903313 Shocktower 966 Carbon Rear
Price:
NZD$36.15
Brand:
Serpent
Model:
SER903313
Condition:
Brand New
Write a review

Sharper Handling with the Serpent 903313 Rear Shock Tower

Drivers looking to tighten rear-end response will appreciate the Serpent 903313 Carbon Rear Shock Tower, built for the 966 chassis. It increases torsional stiffness so the suspension reacts more consistently through corners.

Why Carbon Makes a Difference

Carbon fiber construction reduces flex where it counts, lowering unsprung mass and improving feedback through the shocks. That combination helps the chassis remain composed on rough or bumpy sections.

Simple Fit for 966 Chassis

This tower is manufactured to match the Serpent 966 mounting pattern for a clean installation. No major chassis changes are needed, so you can test setups quickly between sessions.

Will the Serpent 903313 affect corner balance?

Yes, it will increase rear stiffness which often shifts balance toward more stable rear traction; adjust front settings if needed to keep balance neutral.

Is any drilling or trimming required for fitment?

No trimming is normally necessary when fitting to a genuine Serpent 966 chassis; just use the factory screw locations and hardware.

Can this part be used for off road practice?

It is suited for on road and prepared off road layouts where added stiffness helps handling, but check for impacts on rougher, high jump tracks.

Any tips for setup changes after fitting this tower?

Try increasing rear droop or increasing rear spring preload slightly to find the best roll balance after installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved