Serpent 903337 966 Rear Antirollbar Set  [SER903337]

Serpent SER903337 Antirollbar set 966 Rear (3)
Price:
NZD$48.24
Brand:
Serpent
Model:
SER903337
Condition:
Brand New
Write a review

Fine-Tune Your 966 with Serpent 903337 Rear Bars

The Serpent 903337 Rear Antirollbar Set is tailored for the 966 chassis and contains three wire antirollbars in 2.2mm, 2.5mm and 2.7mm sizes. These bars let you adjust rear roll stiffness to match different track layouts and grip levels.

Secure Mounting and Adjustment

Each antirollbar includes balls and spacers so the installation is straightforward and stays tight under load. The stepped sizing gives a clear progression for tuning rear-end behaviour during testing sessions.

Compatible Parts to Consider

For maintenance or further tuning, individual antirollbars and replacement balls and spacers are available and designed to work with the Serpent 966 chassis. Swapping bars is a quick way to change handling without heavy setup work.

Can I use these on other Serpent models?

The geometry is made for the 966 chassis; other models may need different bar lengths or mount positions so check fitment before fitting.

Will thicker bars increase understeer?

Increasing rear bar thickness typically reduces rear roll, which can increase understeer on high-grip tracks; balance changes should be tested incrementally.

How often should I replace the balls and spacers?

Inspect hardware regularly for wear after heavy use; replace balls and spacers if you notice play or binding to keep handling consistent.

Is any special tool needed to swap bars?

Basic hand tools are enough for most swaps; a small pair of pliers or a pick helps with spacers and ball seating during installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved