Serpent 903339 2.5mm Rear Antiroll Bar for 966 - Track Tuner  [SER903339]

Serpent SER903339 Antirolbar 966 Rear 2 5mm
Price:
NZD$8.73
Brand:
Serpent
Model:
SER903339
Condition:
Brand New
Write a review

Fine-Tune 966 Handling with Serpent 903339 Rear Stabiliser

The Serpent 903339 Rear Antiroll Bar, sized at 2.5mm, is made to sharpen the 966 chassis handling. It tames unwanted roll through high-speed sections and helps maintain steady tyre contact when cornering hard.

Traction and Balance Gains

By adding controlled roll resistance the Serpent 903339 improves balance between entry and exit, helping drivers hit the same lines more consistently on each lap.

Quick Fit and Testing

Built for the Serpent 966 chassis, this antiroll bar uses the factory mounting points so you can swap and test different rates quickly between practice runs.

Can I use this on a modified chassis?

If your chassis retains the stock rear mount geometry the bar will fit. Large layout changes or custom mounts may require machining or adapters.

When should I try 2.5mm instead of softer bars?

Try 2.5mm when you need crisper turn-in and less body roll on smooth, high-grip surfaces. It helps reduce mid-corner wallowing without making the car nervous.

Does it affect rear traction on low-grip tracks?

Adding roll stiffness can reduce traction on very slippery surfaces. Use careful testing and consider matching front bar rates to keep balance.

How often should I inspect the bar?

Check the bar and mounting points regularly for wear or bends after each intense session. Replace if you spot cracks or permanent deformation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved