Serpent 903381 Front Suspension Bracket Set Performance Edition  [SER903381]

Serpent SER903381 Front Suspension Bracket 2011 (2)
Price:
NZD$75.39
Brand:
Serpent
Model:
SER903381
Condition:
Brand New
Write a review

Refine suspension geometry with Serpent 903381

The Serpent 903381 Front Suspension Bracket Set is made to sharpen steering response and boost chassis stability. These components help keep suspension angles consistent under load, which is important for repeatable performance.

Race-minded strength and consistency

Engineered from tough materials, the Serpent front suspension brackets resist deformation and wear during sustained track use. They provide a stable platform for control arms and steering linkages so handling stays predictable corner after corner.

Designed for a clean, accurate fit

These brackets are produced to match Serpent mounting points and are straightforward to fit, giving correct alignment without extensive setup. Replace worn brackets or upgrade to reduce flex and preserve tuning choices.

Will these brackets work with aftermarket uprights and arms?

They are compatible with many Serpent-standard uprights and arms, but you should check dimensions and hole spacing when mixing brands.

How do these brackets affect handling balance?

By reducing unwanted flex at the suspension mount, they help maintain intended camber and toe settings, which improves front-end consistency.

Are bolt sizes and hardware included?

Check the product listing for included hardware; if not supplied, use manufacturer recommended fasteners sized to your chassis spec.

Any setup tips after fitting new brackets?

After fitting, recheck alignment, toe and camber, and do a short test run to confirm handling before a full session.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved