Serpent 903556 Lightweight Front Wishbone Set - Track Tuned  [SER903556]

Serpent SER903556 Wishbone Front Lightweight Left + Right
Price:
NZD$11.84
Brand:
Serpent
Model:
SER903556
Condition:
Brand New
1 Reviews
Write a review

Clean handling upgrade with Serpent wishbones

The Serpent 903556 Lightweight Front Wishbone Set offers a tidy way to enhance front-end response on your RC car. Designed to trim weight while keeping strength, these wishbones help you refine steering feel and improve lap consistency.

Improved feel and robust construction

Produced from durable materials, the Serpent front wishbones aim to resist wear from regular track use. Their lighter profile increases steering sensitivity, helping drivers make quicker corrections without compromising part life.

Compatibility and quick swap

These wishbones are made to work with a wide selection of chassis layouts and install using common hardware. A minimal parts swap gets you improved suspension performance with little downtime between sessions.

 

Product Reviews
1 Reviews
rating
RCJAZ has done an excellent job in my order. Response to email regarding part availability was quick. The shipping is within stated number of days. Parts were packed nicely. Will definitely order again in the future.

Do I need new ball studs or pins?

Often the original hardware will fit, but it is good practice to check ball stud height and pin diameter. Replace worn studs or pins to maintain correct geometry.

Which surfaces benefit most?

You will notice the biggest handling gain on smoother club tracks and well prepared circuits where reduced unsprung mass improves steering precision.

Can I tune ride height with these?

Ride height and camber are adjusted through your shock and hub settings, but the lighter wishbones can change dynamic behaviour, so revisit setup after fitting to dial in balance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved