Serpent 903675 Precision Aluminum Rearplate S988 Edition  [SER903675]

Serpent SER903675 Rearplate aluminum S988
Price:
NZD$46.62
Brand:
Serpent
Model:
SER903675
Condition:
Brand New
Write a review

Precision Rearplate for S988 by Serpent

The Serpent 903675 Aluminum Rearplate is engineered to match the S988 chassis mounting layout and improve rear stiffness. Fabricated from quality aluminum, it reduces flex and maintains alignment for suspension linkages under race conditions.

Better Control Through Consistency

This aluminum rearplate helps maintain consistent geometry lap after lap, improving predictability in corner entry and exit. The material choice balances durability with a compact form to avoid excessive weight transfer.

Built for Club and Track Use

Whether you run club nights or weekend events, the 903675 rearplate gives a tougher mounting point that sustains repeated impacts and keeps handling stable during competitive runs.

Does the Serpent 903675 accept the original hardware?

Yes, it is made to the same hole pattern as the factory part, so stock screws and spacers typically fit without modification.

Will this plate work with aftermarket suspension arms?

Most aftermarket arms that fit the S988 geometry will be compatible, but check arm mounting offsets to ensure no interference with the thicker aluminum plate.

How should I protect the finish after crashes?

Light scuffs are normal; touch up with fine sand and clear coat if needed, and replace the plate if bends or deep gouges affect fit.

Does the plate affect ride height or setup?

There is minimal change to ride height, but the increased stiffness can influence anti-squat and roll, so small setup tweaks may be helpful.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved