Serpent SER903738 Rear Lightweight Aluminium Bearingblock - Performance Trim  [SER903738]

Serpent SER903738 Bearingblock Rear Lightweight Aluminium
Price:
NZD$99.57
Brand:
Serpent
Model:
SER903738
Condition:
Brand New
Write a review

Rear Weight-Saving Bearingblock for Viper 989 GP

For owners tuning a Serpent Viper 989 GP, the Serpent SER903738 Rear Lightweight Aluminium Bearingblock offers a focused way to reduce mass at the rear. It is built to keep structural integrity while helping the car turn more readily.

Precision Machining for Stable Response

Built from lightweight aluminium, this bearingblock cuts grams without compromising on durability. Accurate machining improves alignment and keeps rear bearings running smoothly under race loads.

Simple Swap-In Fitment

Designed to match the Viper 989 GP rear mounts, installation is straightforward and requires minimal chassis changes. Hobbyists can fit the part quickly with common tools and basic mechanical knowledge.

Is special hardware needed to fit this bearingblock?

The part uses standard mounting holes for the Viper 989 GP, so normal screws and hardware supplied with the car should work. Keep original fasteners unless damaged.

Will aluminium affect durability in club use?

A well-machined aluminium piece offers a good balance of lightness and toughness for regular club racing. Inspect after hard impacts as you would any metal part.

Should I change my suspension setup after fitting it?

Minor setup tweaks may improve balance after reducing rear mass. Try small roll center or shock adjustments and compare lap times before committing to big changes.

Can I paint or anodise the aluminium part?

Surface finishing is possible but ensure any coatings do not interfere with bearing seats or mounting faces. Light anodising is common and can protect the alloy.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved