Serpent SER903782 Precision Servo Saver Shaft Inner for S989  [SER903782]

Serpent SER903782 Servo saver shaft inner S989
Price:
NZD$22.81
Brand:
Serpent
Model:
SER903782
Condition:
Brand New
Write a review

Regain Accurate Steering with Serpent SER903782

The Serpent SER903782 Servo Saver Shaft Inner for the S989 provides a straightforward way to get steering response back to factory behaviour. It is tailored to slot into the S989 steering stack for a tidy repair.

Where This Part Shines

As a direct replacement, this inner shaft reduces play and restores crisp steering feel. It suits racers and hobby drivers who want consistent wheel input and dependable operation lap after lap.

Maintenance and Fit Notes

Swap the shaft with basic workshop gear and check neighbouring components at the same time. Keep the shaft free of grit and apply a small amount of suitable lubricant to pivot points where needed.

Is this a direct bolt-in for the S989?

Yes, it is manufactured to match the S989 steering components for a direct replacement. Confirm fit visually before final assembly.

What tools are recommended to fit it?

A set of metric hex drivers, clean working surface and a pair of pliers are usually enough. Keep fasteners snug but avoid over-tightening.

How should I inspect the saver after racing?

Check for side play, scoring on the shaft, and any looseness in the servo horn. Replace the inner shaft at the first sign of wear to protect nearby parts.

Can I reuse other parts when replacing this shaft?

You can usually reuse springs and small fixings if they are in good condition, but inspect bearings and links and replace anything with excessive wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved