Serpent 903865 - Aluminium CVD Driveshaft for Viper 990E Short Shaft  [SER903865]

Serpent SER903865 Driveshaft cvd FR Aluminium short
Price:
NZD$49.29
Brand:
Serpent
Model:
SER903865
Condition:
Brand New
Write a review

Precision CVD for Short Shaft Viper 990E

The Serpent 903865 aluminium driveshaft CVD is crafted for Viper 990E owners who want a precise, track-ready replacement. Manufactured with close tolerances, it improves power transfer while resisting everyday wear from racing conditions.

Lightweight Strength

Forged from carefully selected aluminium, the Serpent 903865 keeps weight low without sacrificing toughness. The short CVD design reduces rotating mass and delivers a sharper, more predictable response when accelerating out of corners.

Straightforward Installation

Engineered to match Viper 990E mounts and clearances, this driveshaft fits neatly into the existing driveline. The Serpent 903865 allows quick installation and minimal alignment work to get you back to testing sooner.

Does the Serpent 903865 need special tools to fit?

No special tools are required beyond standard RC metric sockets and a hex driver. Careful attention to centring will ensure a smooth install.

Is aluminium better than steel for this application?

Aluminium offers a favourable strength to weight ratio for high RPM drivetrains, helping reduce unsprung and rotating mass while remaining durable for race use.

Can it be used with stock Viper 990E differentials?

Yes, the Serpent 903865 is designed to work with the standard Viper 990E differential layout, though final checks on clearance and runout are recommended.

Any tips for initial setup after install?

After fitting, run the car slowly to check for vibration and re-tighten drive hardware. Confirm there is no binding through full suspension travel.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved