Serpent SER904149 Midshaft Inner 988E Service Part  [SER904149]

Serpent SER904149 Midshaft Inner 988E
Price:
NZD$22.81
Brand:
Serpent
Model:
SER904149
Condition:
Brand New
Write a review

Keep the Viper 988-e EP Running Smoothly

The Serpent SER904149 midshaft inner 988E is a purpose-made replacement component for the Viper 988-e EP line. It is intended to restore correct drivetrain geometry after wear or damage.

Build Notes

Designed to slot into the existing midshaft assembly, this inner part helps preserve drivetrain alignment and reduces unwanted vibration. It is simple in form but important for consistent handling.

Installation Notes

Install using clean bearings and the correct fastener torque. Verify shaft rotation by hand before powering up to ensure there is no binding or misalignment.

Can I use this part with tuned differentials?

Yes, the midshaft inner works with standard diff setups used in the Viper 988-e EP, but ensure the diff height and preload remain unchanged to preserve handling characteristics.

Should I add grease when fitting this part?

Light grease on contact points and clean bearings before assembly helps prevent corrosion and reduces mating wear, but avoid excess that can attract dirt.

Is any modification required to fit this inner?

No modifications should be necessary for a standard Viper 988-e EP chassis. It is intended as a direct-fit replacement; always check the part number SER904149 against your parts list.

How do I check for wear on the midshaft inner?

Inspect the internal bore and contact surfaces for scoring and measure for radial play. Any looseness or visible damage suggests replacement is needed.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved