Serpent SER904174 19T Pinion - Precision Tooth for 988E  [SER904174]

Serpent SER904174 Pinion 19T 988E
Price:
NZD$27.14
Brand:
Serpent
Model:
SER904174
Condition:
Brand New
Write a review

Improve Viper 988-e Drive Response with Serpent SER904174

The Serpent SER904174 19T pinion gear offers a straightforward way to adjust the Viper 988-e EP gearing. Built to accurate dimensions, this 19T provides clean engagement and steady power delivery for race or club runs.

Built to Withstand Track Use

Made from durable material, the Serpent 19T pinion copes with high load situations and frequent swaps. Its compatibility with the Viper 988-e helps reduce drivetrain play and makes installation simple so you can get back on track fast.

Easy Ratio Experimentation

Hobbyists can use the 19T to explore different gearing combinations and refine throttle response for technical or flowing circuits. Its predictable behaviour helps when matching motor characteristics to the course.

Can I use the Serpent 19T on other models?

It may fit other vehicles with the same spline and gear module, but it was made for the Viper 988-e. Measure shaft diameter and tooth module to confirm fitment.

Which motor setups work best with a 19T pinion?

The 19T suits a range of electric motors; match the pinion to your spur gear and battery to keep motor RPM in an efficient range. Use telemetry or timing changes to find the right balance.

Do I need special tools to swap the pinion?

A small hex driver or pinion puller and a feeler gauge for mesh are usually enough. Follow safe procedures and check mesh under load after installation.

How often should I inspect the pinion teeth?

Inspect teeth after heavy sessions or if you notice noise or slippage. Regular checks prevent drivetrain damage and keep performance consistent.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved