Serpent SER904177 22T Precision Pinion for Viper 988E  [SER904177]

Serpent SER904177 Pinion 22T 988E
Price:
NZD$27.51
Brand:
Serpent
Model:
SER904177
Condition:
Brand New
Write a review

Sharpen Drive Response on the Viper 988E with the Serpent 22T

The Serpent SER904177 22T pinion is built for use with the Serpent Viper 988E EP, offering accurate tooth geometry for improved power delivery. It supports reliable operation whether youre tuning for lap times or club racing.

Compatibility and Where to Use It

This 22T pinion is matched to the Viper 988E EP platform to ensure correct fitment and drivetrain alignment. Use it when you want predictable acceleration and steady top-end behaviour on a variety of surfaces.

Mounting Hints for Best Performance

Install the Serpent 22T pinion with careful motor alignment and secure the gear to the motor shaft using the correct fastening method. After installation, run a short test and recheck mesh and retention to avoid premature wear.

Will this fit straight onto other EP models?

The SER904177 is specifically intended for the Viper 988E EP. Other models may require different shaft sizes or pitches, so verify compatibility first.

What maintenance keeps the pinion lasting longer?

Keep the gear and surrounding area free of grit, check mesh regularly and replace the pinion if teeth show deformation. Proper lubrication of the spur is also helpful.

Is changing pinion size a good way to alter gearing?

Yes, adjusting the tooth count alters final drive ratio. When swapping sizes, ensure the new pinion still fits the motor shaft and maintains correct mesh with the spur.

Any quick checks after installation?

Spin the drivetrain by hand to listen for binding, then run at low speed and recheck mesh and mounting screws. This prevents damage on first runs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved