Serpent 904186 Viper 989E Steering Mount - Durable Fit [SER904186]

Serpent SER904186 Mount steering-servo 989E

Price:

NZD$13.51

Brand:

Serpent

Model:

SER904186

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Upgrade steering control on your Viper 989E

The Serpent 904186 Steering Servo Mount is tailored for the Serpent Viper 989E EP chassis, providing a sturdy base for the steering servo. Its fitment reduces unwanted movement and helps retain accurate steering geometry during high-load turns.

Why this mount works for racers

Serpent 904186 is built to maintain servo alignment under race conditions, ensuring predictable response lap after lap. It is a straightforward swap for anyone replacing a worn bracket or seeking a firmer mounting point.

Installation pointers

Remove old mounting residue and clean screw holes prior to installation for best fit.
Confirm the servo arm and linkage travel after refitting to avoid binding.
Inspect the mount regularly, especially after off-road or rough-track sessions.

Can I fit this to an older Viper chassis?

The Serpent 904186 is optimised for the Viper 989E EP layout. Older chassis may differ in mounting points, so verify measurements before fitting.

Do I need shims or washers when fitting?

Use thin washers if needed to fine-tune servo alignment. Shims can help correct minor height or offset differences without modifying the mount.

How do I check for correct alignment?

Center the servo horn, attach the linkage, then move the steering lock-to-lock to confirm smooth travel with no twist in the mount. Adjust as required.

Is this mount compatible with carbon upgrades?

It pairs with standard chassis materials; if you run a custom carbon top deck, check that screw positions and clearances match the Viper 989E pattern.